Probe atornillar el escalar en los agujeros del borde pero
![nonono :noway](./images/smilies/no_no.gif)
habia logrado 33 TP en el 58w y solo captura 11tp.
Como la mayoria de los satelites son lineales voy a poner otro lnb de carona con dielectrico y entre los que consigo no se cual sera mejor
DMS BSC421
Ya tengo uno de estos
Input Frequency 3.4 GHz to 4.2 GHz
Output Frequency 950 MHz to 1750 MHz
LO Frequency 5.15 GHz (5150 MHz)
LO Frequency Stability ±1.5 MHz @ -40°C to +60°C
Noise Figure 13°K (Typ.)
Conversion Gain 65dB (Typ.)
Output VSWR 2.0:1 (Max.)
V/H Isolation 23dB (Min.)
Image Rejection 40dB (Typ.)
P 1dB Gain Compression -5dB (Min.)
Phase Noise -75dBc/Hz (1 KHz)
Vertical Horizontal Switch Control (V) 11.5v to 14.2vdc, (H) 15.5vdc to 21.0vdc
Output Connector 75 ohm F type
c1w-pll titanium
IF Output Ports 2
Input Frequency Range 3.70 ~ 4.20GHz
Output Frequency Range 950 ~ 1450MHz
L.O. Frequency 5150MHz
Noise Temperature 15K typical
LO Stability (over temp ex offset) ± 50Khz
LO Phase Noise @ 1Khz -72dBc
LO Phase Noise @ 10Khz -81dBc
LO Phase Noise @ 100Khz -90dBc
Conversion Gain 65dB typical
Gain Flatness ±4dB
Gain Variation ±1dB / 27 MHz
Image Rejection -45dB
Crosstalk Isolation 20dB typical
Control Signals Ca [V/CR] 11.5 ~ 14.0V
Control Signals Cb [ H/CL] 16.0 ~ 20.0V
DC Voltage 11 ~ 20Vdc
Current 145mA [max]
Output VSWR 2.0 : 1
Temperature Range -22 ~ +140°F / -40 ~ +60°C
Relative Humidity 0 ~100% condensing
Polarization Type (cast ±45° scale) Linear (w/dielectric for circular)
Output Impedance 75Ω
Connection F-Type / 3GHz / Female
Weight 10.1oz / 286g
Construction Precision Cast Aluminum
Hardware Stainless Steel Allen Head (w/tool)
Housing / Scalar Finish Polyurethane Powder (chip resistant)
Color Snow White / Natural Cooling Fin
Feedhorn Cover RF Low-loss (blue color)
Dimensions (w/o scalar) 7⅝ (l) x 4⅜ (h) x 2¾ (w) in 185 (l) x 87 (h) x 68 (w) mm
Scalar Type * Flat - Prime Focus, 3 Ring
F/D with included Flat Scalar 0.32 ~ .44+ (cast scale)
Mount Type with Flat Scalar Single pole, Tripod or Quad legs
* Optional Conical Scalar Kit – SC1 Offset Type Dish with F/D .5 ~ .8